Seagull Models Extra 260 Spezifikationen PDF herunterladen (Seite 9)

www.seagullmodels.com

Wing bottom.

HORIZONTAL STABILIZER.

Attach the string to the servo lead and

carefully thread it though the wing. Once you

have thread the lead throught the wing, remove

the string so it can use for the other servo

lead. Tape the servo lead to the wing to prevent

it from falling back into the wing.

Electric wire.

Thread.

Repeat the procedure for orther wing

haft.

Plastic tape.

Aileron electric.

Wing panel bottom.

Thread.

Electric wire.

Pull.

Secure the servos with the screws pro-

vided with your radio system.

!1) Using a ruler and a pen, locate the

centerline of the horizontal stabilizer, at the trail-

ing edge, and place a mark. Use a triangle

and extend this mark, from back to front,

across the top of the stabilizer. Also extend

this mark down the back of the trailing edge of

the stabilizer.

! 2) Using a modeling knife, carefully remove

the covering at mounting slot of horizontal sta-

bilizer ( both side of fuselage).

Center line.

! 3) Slide the stabilizer into place in the pre-

cut slot in the rear of the fuselage. The stabi-

lizer should be pushed firmly against the front

of the slot.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 22 23

Keine Kommentare

Seagull Models Extra 260 Spezifikationen Seite 9